Remove Debug View (QteRemoveDebugView) API

The Remove Debug View (QteRemoveDebugView) API removes a view of a module that was previously registered by the Register Debug View API. This API is needed when a program is to be removed from debug, so that it can be deleted and recompiled. Once a view is removed from being debugged, its view number may not be used again.

If the last registered view of a program is removed, all breakpoints are removed from that program, and the step statement is disabled if it was active.

Required Parameter Group

View ID

INPUT; BINARY(4)

The ID of a view to be removed from debug. This ID was obtained from a previous use of the Register Debug View API.

Error code

I/O; CHAR(*)

The structure in which to return error information. For the format of the structure, see Error Code Parameter.

Error Messages

CPF3CF1 E

Error code parameter not valid.

CPF3CF2 E

Error(s) occurred during running of &1 API.

CPF9541 E

Not in debug mode.

CPF9542 E

View not found.

CPF9549 E

Error addressing API parameter.